Banded Belts are made up from Classical, Wedge or Narrow belts with strong tie band over them. Each band may contain the required number of belts. Maximum up to 5 belts in one tie, depending upon the drive conditions, are recommended.

Application:

Optiset Banded belts are recommended on drives under the conditions of :-

• Severe vibrations
• Vertical shaft drives
• V-flat drives
• Agricultural drives
• Conveyer systems
• Crushers, Compressors, Generator sets, Pumps, etc.

Features:

• Antistatic
• Temperature Range :- 18° C to 70°C
• Recommended number of Ribs = 5 (Max

Note:

• While using banded belts it is always recommend to use standard pulleys with proper guard only
• The proper belt sitting can only be obtained if the pitch distances maintained for the belts and for pulleys are same.
• We recommend that the customer get back to us with details before using banded belts to enable us to provide the best suggestions. Improper design using banded belts can lead to rapid failure of the drive system.

Range:

Section	Dimension		Angle Deg	Pitch Distance mm	Standard	Min Pulley Dia	Nominal Length
	A mm	B mm
HB	17.0	13.0	40	19.0	ISO 5291	130 de	Inside
HC	22,0	16.0	40	22.5	ISO 5291	210 de	Length
HSPZ	10.0	10.0	40	12.0	BS 3790	67 dp	In
H3V	9.7	10.0	40	10.0	ISO 5290	67 dp	Inches